The Best Practices When Using Painter’s Tape

Fun fact: Masking tape was the original tape used for painting jobs, but it was a bit too aggressive on certain surfaces.  The masking tape worked fine at protecting areas while painting but removing the tape often peeled away dried paint with it.  Tape manufacturers gradually refined the adhesive to become low-stick painter's tape which has largely replaced ordinary masking tape.  Check out these best practices to use when working with our Tiger Tough painter’s tape: 

Tips for applying painter’s tape 

• Make sure the surface is clean, dry, and dust-free so the tape can stick properly.

• When possible, remove all hardware.

• Apply tape onto the surface while pressing down as you go.

• Secure the tape by pressing down on it firmly with a smooth edge.

• When taping off large areas, slip the roll of painter's tape over your wrist to keep it handy. This is helpful when painting ceiling molding and high trim from a ladder.

• Shorter strips of tape are easier to apply and don’t get tangled. Overlap the edges for easy removal.  

 Tips for removing painter’s tape 

• Wait until the paint fully dries before removing it.

• You can leave our Tiger Tough painter’s tape on for up to 14 days without worrying about any residue.

• Start at the opposite end of where you began and pull the strip of tape back on itself in a steady, slow motion at a 45-degree angle to the painted surface. 

 Following these tips should ensure you’ll consistently get great results.  Our painter’s tape prevents paint bleeding and delivers sharp paint lines every time.  Get it here.